[niggler]

those hours of time spent writing the code could have been saved by spending minutes learning the standard way of doing it (and given the ubiquity of nc, its utility would stretch far beyond this use case)

I dont begrudge people reinventing the wheel, but i fully suspect this wouldn't have been written if the author knew about nc.

[diginux]

It wasn't many hours and I know nc and have used it this exactly way. However, nc requires you know the hostname, an assumption I didn't want to make.

I appreciate the criticism though, it is always good to question the investment of time. In this case, I feel comfortable with it. Can't discount the joy of programming little things either.

[niggler]

If you read the `nc` manpage, you'd notice that the -n option on osx and debian disables host lookup and that hostname is defined as

     hostname can be a numerical IP address or a symbolic hostname (unless the
     -n option is given).  In general, a hostname must be specified, unless
     the -l option is given (in which case the local host is used).

[entropy_]

You still need to know the IP. I use nc this exact same way, and it's definitely a hassle -- not a big one, but still -- to have to check ifconfig on one of the machines and then re-input the IP on the other. On internal networks where IPs are assigned by DHCP on connection and can and do change frequently this essentially needs to be done every time you send a file.

I'm not saying that it's such a big hassle that we need complicated ways of avoiding it, but this is definitely a cool project that does a away with a (minor) pain point and I for one applaud the author for scratching his itches and sharing with the world, even if his hack isn't perfect.

[niggler]

nc does this with the broadcast addresses (read https://en.wikipedia.org/wiki/Broadcast_address for more info):

Recipient listens on 0.0.0.0:

    recipient$ nc -l 0.0.0.0 6969 > file

Sender broadcasts to broadcast address:

    sender$ <file | nc 192.168.0.255 6969

or

    sender$ <file | nc 255.255.255.255 6969

[diginux]

1. In general, I am on the computer I want to send from, then I go to the computer I want to receive on. This script seems to require I be at the receiving computer first. Is there a trick to do it my way?

2. A very minor point, but you are still required to know (or at least specify) a the filename on the receiving end. My solution does not.

[niggler]

To solve both complaints, just tar -c on the ingress and tar -x on the egress:

    sender$ tar -c file | nc -l 12345
    recipient$ nc addr 12345 | tar -x

This will create a file on the recipient side with the specified name and properties (and you run the sender command first)