How about "non-professionals"? It could be useful to check device before sending for pre-compliance / compliance checks and save money - that would avoid very expensive iterations.
But there are already benchtop or handheld signal analyzer for that purpose.
This seems more like a tool for checking across entire large assemblies like an entire building, car, aircraft, etc, for unknown sources. If you have an individual discrete device that you're already testing, just using traditional instrumentation seems reasonable, but on a large, complex assembly, I can see it being useful. Also useful for things like detecting if a particular antenna is working without actually going up there to measure near it; if you have a MIMO setup with multiple antennas, this might make it easier to check if all of them are working correctly when mounted in inconvenient areas.
I think that for a single device, this probably wouldn't help much over just having a more traditional signal analyzer, either benchtop or handheld. If you know what you're testing, just using a signal analyzer around it will give you a good first pass picture of emissions, and probably be much more informative and precise than this.
This seems more useful for finding unknown or hidden RF sources, for instance looking thorugh an entire building to find unknown RF sources, or maybe a whole complex assembly like a car or aircraft.
I don't think it's any good for that. It's relatively narrowband and not the frequency you usually have issues with EMC on (5 to 6GHz - unless you are specially transmitting on this frequency you are unlikely to emit anything there).