[JKCalhoun]

So much in there: so much hand-soldering of SMD, the way he made an SMD resistor bridge to bodge his MOSI/MISO mixup, using the Bambu 3D printer as a test harness (with pogo-pin attachment) to test his "blades"…

(I thought he was going to end up with R2-D2; the way the design was going…)

[superxpro12]

The automated programming fixture/conversion was pretty sweet, im not gonna lie about that.

[rbanffy]

> I thought he was going to end up with R2-D2; the way the design was going

This is still a partial build, so things might change a bit.

For me, I think it’d be cool to have the boards back to back so LEDs would always show.

[klysm]

I always leave a 0 ohm DNP on any TX/RX line.