[guenthert]

> use two separate ADCs at two different gains and combine their output

That's what could be done if ADCs were perfectly linear and noise free and limited only by their bit-width. Sadly, they are not. The non-linearity one can in theory measure and correct for, but the noise can be corrected for only by oversampling. And then you might as well use a single ADC of lesser bit width and higher sampling rate.

[amluto]

I feel like you’re arguing against a straw man.

No one is arguing that there are practical audio microphones + ADCs that produce accurate, undistorted 32-bit float output across the full representable range. But they don’t need to! For professional use, the ability to produce perceptually accurate output, with inaudible noise, across a very wide dynamic range, is extremely useful. Think of it as fancy, real-time AGC. It does not need to be perfect. If you can record a loud transient without substantial distortion, and also record sounds with 2^16-fold lower amplitude (~96dB lower) while still remaining well above the noise floor immediately after the transient is gone, this ability is useful. Plenty of real-world noises are well above 120dB, and plenty of human-audible sounds are below 20dB. You can’t play back the recording, at least not without making parts inaudible or injuring your audience, but you can edit it. And a setup like this lets you do it with one microphone and no fiddling with gains in advance.

[nok22kon]

this uses 2 ADCs:

https://tascam.jp/int/feature/32-bit_float

[guenthert]

One cannot create a noise-free, perfectly linear 32b ADC using 2 lesser ADCs as described above. That is however not needed and I suspect isn't what they are attempting.

If, say, two 24b ADC (20b noise free, non-linearity 2LSB) with one receiving the input signal with an approximate 10bit higher gain (+60dB) and one would combine their outputs with that 10b shift (and ignoring the input of the low gain path, if the signal falls below a given threshold to reduce the noise contribution of that ADC and the input of the high gain path if the signal exceeds another threshold in order to avoid clipping), then one could construct a 32b float.

This doesn't improve resolution (which arguably would be pointless) or linearity (not all that critical in audio methinks) but dynamic range, which I can see some appeal of (in extreme recording situations, say you'd want to record the breathing of a shooter followed by the gun shot -- there remains the challenge of finding a microphone capable of a 120dB range, but perhaps one could use two different ones ...).