[nazgu1]

I considered buying bambu lab A1, bout watching this and previous dramas I rather go with different vendor. Are there any good alternatives for newcomers? I like hacker nature and openness of Prusa, but I’m worried if it is good printer as a first one…

[Mashimo]

Prusa printer are really good. Well at least a few month after the first release :D They tend to release banana products that ripe at the customers.

But for example I had some problems with my linear rods, talked to support for just a few minutes and 2 days later I had replacement parts at my door. This was a few years back though.

Also they give firmware updates, and even hardware upgrade for years! This IS really nice and I'm not sure any other printer manufacturer that sells to private people does this.

Yes, your upfront price is a bit higher. I say it's worth it.

[robotmay]

I bought an Elegoo Centauri Carbon late last year and that's been very good so far. Had a minor issue of a sensor disconnecting after a month, but took 10 minutes to fix it (cable had come loose, probably in transit).

It was absurdly cheap for its spec (£260 is what I paid, delivered) and can be run entirely without internet access with no issues. People were a bit miffed when they announced a v2 with multi-filament support, but they just announced an addon to upgrade the first version to a similar spec and it's again really cheap - £55 delivered here in the UK.

If I was printing more professionally I'd probably go for a Prusa, but the cost/benefit isn't there for someone new to it, unless you have plenty of dosh - in which case go for it. As someone getting into it, the price of the Centauri Carbon is so reasonable that it's hard to argue against it.

[htgb]

I got a second hand Prusa Mk3s about a year ago as my first printer, around 300 € perhaps. I'm still enjoying it a lot, even though I'm now eyeing one of their upcoming (more expensive) models.

I think it depends mostly on how you expect to use it. There may be alternatives that give you perfect prints with minimal fuzz. But for me it was great to have a machine I dare play around with. Like getting a tractor before a race car :)

[dracotomes]

I've only had one Prusa printer, a MINI+ and it's been an absolute workhorse and easy to repair using the official instructions (I assembled my unit myself and pulled a zip-tie too tight, which caused the part cooling fan cable to break). You do pay a premium. I, personally, also found PrusaSlicer to have better presets and usability than OrcaSlicer or it's forks.

[shuv1337]

it honestly depends on your budget. prusa is definitely overpriced for what you get. but, i bought one anyway specifically because of their stance on OSS, and this kind of bullshit the bambu is pulling. even though bambu objectively has a better or at least equal product for significantly less money.

[imhoguy]

Less money because you get significantly closed product likely susbidised by state to dominate the open competition.

[jijijijij]

Yeah, overpriced is a big word when the competition is likely not operating sustainable due to subsidies and a lot of investment cash to burn for market capture.

Eg. they are paying random people to host their models exclusively on MakerWorld (where the CCP tells you what's okay to print; try searching for anything 'Jinping'...). They are obviously pouring enormous amounts of cash into marketing on social media, especially YouTube (a lot of large maker channels became full-on advertisement platforms).

Their expenses are evidently enormous. There is no way they are running sustainable. It's a long con.

[i5heu]

You have to consider that you do not own the product from bambu.

So to say you spend significantly less money for a product that will be changed whenever bambu sees fit to whatever extend they see fit.

I regret my bambu purchase a lot. I have to keep up with all the ways bambu wants to lock in my hardware and take it basically away from me.