[Lwrless]

I went a slightly different route. My switches are linked with 10Gbps SFP+ across the apartment, but it was way too late (and too much hassle) to pull proper in-wall fiber. Instead I used one of those ultra-thin (around 0.1mm), unshielded fiber cables, and just snaked it through door frames and taped it along the walls. I'm genuinely impressed this stuff exists, it makes retrofitting fiber into a finished space so much less painful.

Most of my edge devices are still on 2.5GbE though, and I'm increasingly aware that for anything with plain SATA disks, the drives are the real bottleneck. Once I LAG'd 2×2.5GbE to get a 5Gbps pipe, it became obvious the network wasn't the slow part anymore in a lot of cases.

And yeah, the 10GbE SFP+ modules run hot, so hot that I would not lay my fingers on them for more than 2 seconds. I stuck 2 copper heatsinks on my module, not sure they do much but the module runs smoothly. Even so, I'm pretty happy with the overall setup: from my 10GbE-equipped Mac I can saturate multiple machines at once and I no longer think about the network most of the time, which was the goal.

[Lwrless]

And after getting 10Gbps working at home I was getting greedy, and looked at InfiniBand as well, 40Gbps and proper RDMA is very tempting compared to Ethernet. The catch for me was the practical side: IB needs PCIe slots and those chunky, inflexible cables. With most of my stuff being laptops, mini PCs and Macs, I just couldn’t see a clean way to route those or even plug cards in everywhere, so in the end the "door-frame‑friendly" skinny SFP+ fiber still won out for this apartment.

[hju22_-3]

What kind of fiber cables? If you have a link, I'd appreciate it. I can only find ones at 0.5mm.

[Lwrless]

Good catch — that was actually my mistake. I mixed up cm and mm from the marketing material, and when I actually measured just now it came out to around 0.9mm. So not quite as thin as I claimed, and I probably wouldn't have noticed if you hadn't asked.

I did find some Kevlar-reinforced options that are supposedly ~0.3mm, but they seem to be raw fiber without connectors, purposed for drones, and I'm not sure about global availability.

[hju22_-3]

Ah, I see. Thanks for checking. I'm considering doing a similar run at home, so was curious if there were any options that thin. 0.9mm should be plenty to work with. :)