[bee_rider]

I’m kind of surprised there isn’t a CFD setup for PC builders yet. We could model all the parts and run some simulations, as the last hurrah for our old systems. Manufactures could show off their cred by making increasingly detailed models of their parts. It would all be very fun.

[btrettel]

I do CFD in my day job, though not for electronics cooling. I don't think this is as easy as you imagine. It's relatively easy to make pretty pictures, but just because the picture is pretty doesn't mean that it's physical accurate or mathematically correct. Lack of resolution could be an issue, but there are plenty of more subtle problems as well. Jet impingement is known to cause problems with turbulence models, though some models claim to solve the issue. Plus, turbulence modeling isn't always predictive, and might require a certain amount of calibration any time a model is used in a new scenario. Add on top of that the fact that the computational cost of these simulations often is extremely high, even with turbulence models. Maybe people building PCs have plenty of unused CPUs and GPUs, though.

Unfortunately, I don't think CFD and turbulence modeling are things that you can just start doing well without learning a lot before starting.

[bee_rider]

You are probably right, my only exposure to CFD was through listening in at conferences, haha. It seems neat, though. They always had the coolest pictures.

I wonder, could there be any play in the fact that PC cases tend to be a little bit less general than just, like, any 3D model? There are only so many cases. Plus most of the parts are rectangular, and most of the surfaces are aligned the same set of axes.

Cabling might be a problem.