[pseudony]

Same issue (I am Danish).

Have you tested alternatives? I grabbed Open Code and a Minimax m2.1 subscription, even just the 10usd/mo one to test with.

Result? We designed a spec for a slight variation of a tool for which I wrote a spec with Claude - same problem (process supervisor tool), from scratch.

Honestly, it worked great, I have played a little further with generating code (this time golang), again, I am happy.

Beyond that, Glm4.7 should also be great.

See https://dev.to/kilocode/open-weight-models-are-getting-serio...

It is a recent case story of vibing a smaller tool with kilo code, comparing output from minimax m2.1 and Glm4.7

Honestly, just give it a whirl - no need to send money to companies/nations your disagree with with.

[nunodonato]

I've been using GLM 4.7 with Claude Code. best of both worlds. Canceled my Anthropic subscription due to the US politics as well. Already started my "withdrawal" in Jan 2025, Anthropic was one of the few that was left

[bigyabai]

I'm in the same boat. Sonnet was overkill for me, and GLM is cheap and smart enough to spit out boilerplate and FFMPEG commands whenever it's asked.

$20/month is a bit of an insane ask when the most valuable thing Anthropic makes is the free Claude Code CLI.

[mikenew]

I've recently switched to OpenCode and found it to be far better. Plus GML 4.7 is free at the moment, so for now it's a great no-cost setup.

[stavros]

I don't know, I max out my Opus limits regularly. I guess it depends on usage.

[Mashimo]

> I'm in the same boat. Sonnet was overkill for me, and GLM is cheap and smart enough to spit out boilerplate and FFMPEG commands whenever it's asked.

Do you even need an subscription to any service for that? Is a free tier not enough?

[dsrtslnd23]

Are you using an API proxy to route GLM into the Claude Code CLI? Or do you mean side-by-side usage? Not sure if custom endpoints are supported natively yet.

[sumedh]

This works: $ZAI_ANTHROPIC_BASE_URL=xxx $ZAI_ANTHROPIC_AUTH_TOKEN=xxx

  alias "claude-zai"="ANTHROPIC_BASE_URL=$ZAI_ANTHROPIC_BASE_URL ANTHROPIC_AUTH_TOKEN=$ZAI_ANTHROPIC_AUTH_TOKEN claude"

Then you can run `claude`, hit your limit, exit the session and `claude-zai -c` to continue (with context reset, of course).

Someone gave me that command a while back.

[nunodonato]

thats pretty much what I do, I have a bash alias to launch either the normal claude code, or the glm one

[Mashimo]

This is the official guide: https://docs.z.ai/devpack/tool/claude

[stavros]

I much prefer OpenCode these days, give it a try.

[nunodonato]

I did, I couldnt get used to it and didn't get so good results. I think Claude Code's tools are really top notch, and maybe the system prompt