[toast0]

At least the debugger worked. The processor I used in embedded systems in college, the 68HC11, would stop doing conditional branches when the supply voltage was too low.

We had a battery powered board, with no brownout detection, and I was using rechargable NiMH batteries to save money/waste. When the students with alkaline batteries had low batteries, the motor load would bring vcc down far enough that the CPU would reset by itself. With NiMH, the batteries could still drive the motors and keep the CPU alive...

You could single step in the debugger, and see the flag register was set as expected, but the branch didn't happen. Just ran straight through. I can't remember if unconditional jump or call worked. After about the third time this happened, I got good at figuring it out.