|
|
|
|
|
|
by MarkMarine
564 days ago
|
|
|
It is really really difficult to make any thing from a burl that is within the range of a hobbyist that isn’t turned. The grain is impossible, and they are really hard so working it with normal tools (a hand plane or a spoke shave) is just going to tear out as the direction of grain changes. I’ve never seen a veneer cutter that could handle a burl that was within hobbyist reach, but a lathe is going to cost you under 1000$ and probably under 500$ if you get a used one with good capacity. |
|
|