[AstroJetson]

* Panel Saw: Large rack that can hold an entire sheet of plywood (4x8 or EU size 5x5) Saw runs on a tube/sled that lets you cut up / down on the plywood sheet. To make horizontal cuts the saw is rotated 90 degrees. On some panel saws the entire tube and slide will slide from left to right on the saw. On less expensive panel saws there will be a series of rollers along the bottom that lets a panel roll with the fixed saw making the cut. Most panel saws are mounted to walls. I've seen smaller panel saws that can be rolled around (panel sits at a 30 degree angle)

In my shop I have a track that my circular saw, jig saw and router can use for long pieces. I can break full sheets of plywood down. I use foam board insulation. Either on the floor for breaking down a full sheet, or for smaller pieces I put foamboard on my 3x5' workbench.

I have a Mitre saw that I use for small 8" crosscuts. For bigger crosscuts back to the track.

All of my tools are Dewalt 20v tools so I don't need to wrangle cables. The only think I can't do easily is rip small widths of long pieces.

[mft_]

Ah, thanks for clarifying - I've only ever seen one of those in a hardware store, and never heard of anyone having one in a hobby workshop!

Out of interest, which system do you have which allows a jigsaw and router to use your track?

[AstroJetson]

It's an aftermarket track. I bought it because the track comes in 50 inch pieces that can be connected together. I custom built the three sleds (Circular saw, Jig Saw and Router) to use the track as support. But there isn't anything from stopping you from using the track as a long straight edge and sliding the shoe of all the tools along it. It just takes a little finesse to keep the power tool tight to the slide and not let it wobble off.

The three sleds took about 45 mins to make the first one (fiddle-fiddle-fiddle-some-more-fiddle) and then the other two took about 15 mins each.