[wpm]

I think your thermal pad issue was why yours ran so hot, I got one recently in the second batch and I so far haven’t been able to get it over 65C.

The pad I got was about 1-1.25mm thick, not crumbly like yours was on video. I assume they figured out what the issue was with their supplier.

Still think the entire thermal design is whack, a single fan perpendicular to the board on the end could draw air through the heat sink as well as over the SSD on the top. Working on whipping up some 3D printable stuff once I get some time next week.

[geerlingguy]

Glad they finally sorted the thermal pad at least. Everyone in the first order batch I talked to (before it was sold out a while) had the exact same thermal pad. But yes, the heatsink design still has a few drawbacks that should definitely be adjusted in a revision!