[eternityforest]

I'd say if you need more than E3, you either know a lot of not much, unless you're into analog.

I've done stuff that needs high precision resistors, but usually the specific value isn't that important, just that it's a known repeatable value.

[nick238]

If I want a voltage divider, it's a lot easier to just use some 1% resistors and forward-calculate the expected output (rather than doing a calibration) if you're happy with 1-2% error from the resistors and your ADC or the like. Adding software and testing hardware to do a full on calibration is a lot of work.

But yeah, for digital signals, oft times 1k or 100k make no difference.

[eternityforest]

I definitely agree that 1% or better resistors are easier than calibration, but that doesn't mean you need values outside of E3 most of the time.

I might want want an accurate 1/10 divider or something, but a 1/12 divider would probably be fine too, as long as it's consistent. If it doesn't vary between devices, it's just a line of code to change.

[willis936]

For voltage dividers it's best to use matched networks. Often not much more expensive and orders of magnitude more precise.