I've had white plastic SLA prints (not Formlabs afaik) go very yellow in less than a few months, curious if this is common with white photosensitive resins vs plastic you might get injection moulded?
Have not had this in my experience with formlabs. they recommend that you use a protective coating spray for parts that are outside in direct uv, I have never used it though and my parts have lasted fine.
As always depends on the material, I think the glass filled ones are better, the flexible ones are a little worse but it has never been an issue for me.
As always depends on the material, I think the glass filled ones are better, the flexible ones are a little worse but it has never been an issue for me.