[davecb]

The bottleneck device can change with every different destination, so CAKE and fq_codel find it the same way older TCP code did: increase the load until they get a timeout or a "slow down, you idiot" flag (:-))

The initial bandwidth setting is really to get it started at a good value for your usual bottleneck device, such as your local cable modem.

Always starting off as if you had fast ethernet to the ISP when you actually have a super-el-cheapo link is a waste of time and effort. Even if you have a good algorithm like CAKE.

--dave

[p1mrx]

When I used CoDel on OpenWrt years ago, setting a 1 Mbps limit prevented the link from ever going faster. If it's now smart enough to discover the correct limit, then that's an interesting/useful development.

[p1mrx]

Followup: I just tested OpenWrt 23.05.2 + luci-app-sqm + cake with https://speed.cloudflare.com/

With the limit set to 1 Mbps (1000/1000), my upload latency dropped from 80ms to 25ms, but speed was hard-limited to 1000/1000. With the limit rasied to 1G/1G, cake stopped working and my upload latency returned to 80ms.

So I stand by my original comment. You still have to configure the speed limits manually.

[wtallis]

You're right: CoDel and derivatives like fq_codel and cake don't auto-tune anything on timescales much longer than the interval parameter which defaults to 100ms. And fq_codel doesn't even do traffic shaping.

But I think davecb may have been confusing traffic shaper limits with TCP congestion control behaviors, and maybe the impact of a large TCP initial window releasing a sudden burst of packets that may be large enough to build up a bit of a queue on particularly slow links. (It was a serious problem in the ADSL era; now, only wireless gets that slow, and large bursts of packets are as likely to help as not when frame aggregation enters the picture.)

[pixl97]

I mean setting a static traffic control limit was generally a high water mark, and in general even if you had excess bandwidth you didn't want to exceed it.

Now, to get around that some devices perform regular speed tests and dynamically adjust the high water mark. This said there are some limits at which you should perform these tests as too often and you may affect the actual applications you're trying to run.