If you're exposed to figures written in scientific notation, then learn scientific notation (it's not even hard, the number represents the number of zeros you'd write if you had to write it entirely: 5000 = 5⋅10³ / 5E3, 0,0003 = 3⋅10^-4).
As said above, it has nothing to do with the metric system anyway, it's just about dealing conveniently with very big or very tiny value (1⋅10^-9 meter is 3.9⋅10^-8 inch, no matter the unit you're using you'd be using scientific notation to express things that small instead of dealing with 8 or 9 zeros).
Thanks for the advice I never considered trying to learn scientific notation. I think the way the problem manifests in combination with the metric system is that the metric system seems to have an extra 1,000 that may or may not apply.
I think my particular problem is when dealing with electricity and physics.
I never once blamed the metric system and identified the problem as my in ability to comprehend values in scientific notation. I appreciate I shouldn't be so dumb and try to read about things I don't understand. It's a life long struggle.
> is that the metric system seems to have an extra 1,000 that may or may not apply.
You may be getting confused over prefixes vs base units because some pairs of prefixes and base units are so common they sort-of end up treated as a unit in themselves.
E.g. "kilo" is not a metric unit, but sometimes used as short for "kilogram", where "kilo" is the prefix for 1000 and "gram" is the metric unit. These prefixes are consistent for all metric units.
I don't know what to say other than I have a hard time reading scientific notation and the metric system. The metric system seems to lend itself to large numbers that are small quantities on the human scale.
> My problem with the metric scale is that when values are expressed in scientific notion they lose all reference to me.
As if the two are connected. But my point is that scientific notation is not part of the metric system at all. If you problem is with scientific notation, that is a problem with scientific notation, not metric.
If anything, with metric units most people outside of the sciences will use the metric prefixes and never ever use scientific notation at all.
It always amuses me when I watch a machining video from someone using metric. I've just been exposed to too many US machinists and am much more familiar with "thous" and "tenths" but baffled by microns and 0.02mms.
I try to learn but the only thing I think I have retained is that if the number has a negative 6 its most likely a small number.