[yial]

A brushless motor is a 3 phase motor without brushes. A brushed motor is a dc motor with brushes.

I say that because both can spin up very aggressively.

What you’re seeing is not really because it’s brushless- it’s a “soft start” feature… most likely. It could also be that your unit is a variable speed.

Now — I may be completely misunderstanding what you’re asking. If so apologies. I went from an old unit to a newer variable speed, and the starting does seem very smooth, even when cranking up to full vs the jarring and faster spin up of the old unit.

[TaylorAlexander]

I don’t think older A/C units used brushed motors, but A/C induction motors. A/C induction motors often have a clunk when they start, because doing speed control is more expensive than just turning them on all at once. Once you have a brushless motor, you don’t need a clunk anymore to start it, you necessarily have enough control to smoothly start and stop it. But my question is why do they call it an “inverter” motor and is that the same as an brushless motor?

[distract8901]

Inverter refers to the power control system.

Your typical AC unit has a single solenoid that physically makes or breaks the connection across your 240v line. That's the big clunk you hear when the compressor kicks on. This type of control is either all the way on or all the way off.

An inverter topology uses a bunch of electronics to convert your incoming 240v to a lower voltage or even frequency. This gives the electronics very fine control over how the motor works. You can start up slow, or run the motor at 50% or anything you want.

This doesn't really have anything to do with whether the motor itself is brushless. All brushless motors require advanced drive electronics. This usually ends up being pretty similar to an inverter topology, but not necessarily. A brushed motor doesn't care, you can just jam some electricity in and get motion out.

What you think of when you say "brushless motor" is categorically -not- the kind of motor in an AC unit. AC compressors use larger induction motors which may not have brushes, but they are not 'brushless motors'

A brushless motor specifically refers to a particular type of DC motor which uses phased, stationary coils to move a rotor with a ring of magnets. An AC induction motor may use either an iron core in the rotor, or a coil of wire that produces a magnetic field for the stator windings to push against.

[TaylorAlexander]

Gotcha this makes sense. Thank you!