[dwater]

As someone who owns a 1970 car and several motorcycles from the 70's, I would say that this is not true in the US. If you're imagining a wealthy guy with a spotless garage that pays top dollar to keep his antiques maintained in excellent condition, then you're thinking of the minority of antique vehicle owners. I bought my car for $14k and it would cost more than that to restore it (which I don't have). I do my best to keep it in acceptable roadworthy condition, but I also frequently test drive it around the neighborhood knowing full well something isn't working properly.

In my state, vehicles registered as antiques are not required to have the annual safety inspection performed, and it is the owner's responsibility to keep the vehicle in safe operating condition, which is never checked by anyone.

[more_corn]

In California there are about five different classic car rallies. Fifty to a hundred people in pre 1975 cars get out on curvy roads and drive around for a few days. No inspections, no smog tests. No shiny paint. Cars are for driving so drive them. There are mechanical problems and there’s joy in that, breaking down and fixing things, stopping to help/heckle.

The cars could be more safe, but we’re all mechanics by necessity. Failure also reminds us that these are all human made systems. Each can fail. Each can be fixed. In some ways being aware of the systems that make a car go (and stop) and being aware of the failure modes makes the classic car drivers more safe than their counterparts in driving appliances.

[jacquesm]

> I also frequently test drive it around the neighborhood knowing full well something isn't working properly.

That's wildly irresponsible of you. How will you look yourself in the eye if you cause an accident like that? If you can't afford to keep a car maintained you can't afford it, period.

[sgt]

I think if you read it like that, sure it may sound irresponsible.

But in reality it'll look a lot more innocent than that, and I am sure that OP does it carefully enough.

You just gotta make sure the brakes work and that you don't do any silly things. Doing test rides and listening for sounds etc is key to figuring out what's wrong and what to improve next.

[dwater]

Right now the thing that isn’t working properly is the oxygen sensor, so the engine struggles to rev past 3000rpm. I don’t worry much about the potential danger that puts others in.

[jacquesm]

That's an important bit of context I think :)

Air mass sensor failure can often be determined by unplugging the thing completely, O2 sensor failure could be the cause of your problem but if it only starts to fail at very high revs I'd check the fuel system first to make sure that there is enough flow.

Those can get clogged up pretty badly, especially in vehicles that have been standing for a while with ethanol based fuel in them, it takes forever before that gunk clears out without some work, if at all.

If it really is the O2 sensor (of which you usually have two) then I'd suspect the pre-cat one first, it runs in a much hotter environment and is more critical to the engine working properly.

Another option is the crank sensor, they may not give enough signal at a high number of revs so you start to miss if enough pulses fail (one or two in an otherwise consistent signal isn't going to cause the PLL to lose lock but if it is more erratic then it will and then revs would drop back to a regime where the sensor is still working reliably).

Good luck fixing that.