[mlyle]

You're talking past each other.

The electronics perform two key functions:

* Choosing pitch angles for efficiency and turbine safety. You can, for smaller turbines, just synchronize the turbine to the grid, but this is becoming uncommon practice.

* Converting the produced AC power to DC, and then choosing the proper frequency output and voltage to feed power to the grid, and inverting the DC to make this power. This should usually be trying to "speed up" the frequency of the grid a little if it's not already way too fast and regulate the voltage appropriately.

The second link you have, on page 3, shows (active) rectification (d) of the wind turbine AC power to make positive and negative DC buses, and then inversion of that DC (f) to make 3 phase AC output power.

[Gravityloss]

Yeah, I don't know if for example in big wind offshore wind parks, since it's connected with a DC cable to mainland anyway, you would convert all the turbine generator outputs just to DC.

Then at the ground station where it's connected to the grid, convert to AC, whatever kilovolts are needed.

[mlyle]

> you would convert all the turbine generator outputs just to DC.

You could. But you probably still need a DC/DC conversion step or boosting in order to let the power flow from each of the turbines fairly. (The synchronous conversion to DC from AC provides opportunity to slightly change the voltages you get out, but not terrifically so).