[tomahony]

I mentioned this in a HN post in the past regarding standing desks, mentioning that I'd created an over-engineered standing desk controller (using a Raspberry Pi) over lockdown as as little fun project. Somebody asked about a write-up for it, so here it is

[solarkraft]

You say it's over-engineered, but every time I read it I think of something Mr. AvE said about the topic (albeit with physical materials, regarding Juicero, to be precise):

If it uses more material than required for the job it's over-built and under-engineered. Your solution seems to be massively that.

[zaxomi]

Nice project. Do you have an emergency stop button?

[p_l]

Asking the important things here ! :D

Also, what positive safety control loop could a standing desk use?

[watersb]

Thanks for this!

I have yet to actually build anything that controls hardware, but I have been lurking, reading about microcontrollers, collecting little bits.

An actual application, a solution to a real problem or neat project, is the best way to make it real.

[grogenaut]

If you have some disposable income buy an Arduino kit from say elegoo. They come with a lot of little labs, basically 30 min - 1 hour exercises where you take one of the 30 physical devices it comes with and use it.a little bit of Lego like assembling of parts and copying some code from GitHub.

So like a led (light) is one lab. The next might be a photo sensor (signal with amount of light). After these two labs you can now make a night light. Or a rave strobe.

Do the switch or button lab and you can turn it on or off or change the pattern. After 30 labs you have a pretty good idea of what to do.

Now buy an esp32 that works with a breadboard and if you know basic http you now have an iot device.

I recently hooked an esp32 to a dht22 and started graphing temp in my gourmet mushroom enclosure in about an hour of watching baseball. Just sends data to influx and grafana on an rpi data hub