[gkop]

If the wireless charging mechanism is solid state, it’s immune from mechanical wear.

Mechanical wear matters for example if you have a Roku, and the buttons in the remote control physically wear out. You can just instead use your phone app to control it over WiFi, and the WiFi antenna will “never” wear out because it’s solid state. Source: I have an old Roku

[sudosysgen]

It's a good rule of thumb, but that doesn't check out in practice.

The wireless charging mechanism, while solid state, generates a lot of heat, which has the potential to degrade the battery especially in certain climates.

[Retric]

Solid state devices can still fail from mechanical stress. Heat cycling and strong magnetic fields could be a problem for wireless charging even if they don’t need to be. The core issue is generally trying to use the cheapest solution, not just mechanical stress.

Ethernet connectors are probably the best example of this, for servers that might be moved every few years their cheap and maintain a solid connection. It’s really desktops and especially laptops where they become such a major issue.

[gkop]

I’m struggling to understand your point. Phones are closer to laptops in that in typical use a wired power connection is frequently plugged and unplugged, so mechanical wear is an important consideration. Why are you bringing up Ethernet on servers in this context, when as you say the pattern of use is utterly different?

I know almost nothing about wireless charging. But have fair experience with working with WiFi devices. In my lifetime, I have observed 0 cases of failure on the WiFi client mechanism, and exactly 1 case of a WiFi router failing due to hardware. Meanwhile, power plugs are the most common part I have experienced wearing out on consumer electronics. Have you experienced lots of failures of solid state electronics due to eg. hear cycling and magnetic fields?

[Retric]

My point was you need to design stuff for the use case and a healthy margin. Incandescent lightbulbs are perhaps the poster child for solid state devices which with a limited lifespan. You can design lightbulbs for a 100 year lifespan at the cost of efficiency and bulb brightness. Even then an incandescent bulbs lifespan is dramatically shorter if your power cycling it every 2 minutes. But eventually stuff like electromigration for example will be an issue for solid state devices. https://en.wikipedia.org/wiki/Electromigration

When designing wireless charging the same efficiency vs lifespan tradeoffs exist. Sure, they might be fine, but don’t expect them to last 20 years or anything. Further, the mats are significantly more expensive than a cable.

PS: Connector specifications are generally a dumpster fire because nobody wants to be forced to build expensive cables. And even if the spec says X, if Y is cheaper and still mostly works then you can bet people will do Y. Failure tends take a while at which point people buy a new cable vs returning the old one etc.

[gkop]

Thanks! Your answer reinforces my personal preference for wires to supply power :)