With Fourier you can analyze oscillatory characteristics of function (frequency and phase). With Laplace you can also analyze amplification/attenuation.
The Fourier transform, well, transforms a time-based phenomenon such as an alternating current sine wave into a frequency spectrum where you can observe the frequency spectrum components of the signal. A pure nice sine becomes a spike (delta function) located at a specific frequency. Music, as we observe it through our ears and can view it on an oscilloscope becomes moving spikes (lots of them :) in the frequency spectrum where the "amplitude" at a given frequency relates to the "amount" of that frequency in the music.
The behaviour of a filter is much easier to describe in the frequency spectral domain than it would be in the time domain.
Now to the direct current (DC) view. This cannot be handled by the Fourier transform -- at least the DC-part of the signal cannot be transformed to the frequency domain. As shown in the article, there were "steps", "ramps" and such. A typical scenario would be to describe what happens in your amplifier during startup, to describe how electrical circuits are behaving during startup before reaching the "running" state.
The Laplace transform will handle these types of scenarios, and can thus be used to study (or describe) systems during other types of transitions than the "steady state" when you are up and running.
Regarding filters, the Fourier transform describes things going on at the unit circle, while the Laplace transform can be used to study both the interior and exterior of the plane. In this sense, creating filters relates to locate "poles" and "zeros" in the plane (amplification and attenuation) which can be observed on the unit circle as the behaviour on periodic signals.
The behaviour of a filter is much easier to describe in the frequency spectral domain than it would be in the time domain.
Now to the direct current (DC) view. This cannot be handled by the Fourier transform -- at least the DC-part of the signal cannot be transformed to the frequency domain. As shown in the article, there were "steps", "ramps" and such. A typical scenario would be to describe what happens in your amplifier during startup, to describe how electrical circuits are behaving during startup before reaching the "running" state.
The Laplace transform will handle these types of scenarios, and can thus be used to study (or describe) systems during other types of transitions than the "steady state" when you are up and running.
Regarding filters, the Fourier transform describes things going on at the unit circle, while the Laplace transform can be used to study both the interior and exterior of the plane. In this sense, creating filters relates to locate "poles" and "zeros" in the plane (amplification and attenuation) which can be observed on the unit circle as the behaviour on periodic signals.