Hacker News new | ask | show | jobs
by nameless912 3573 days ago
Layouts are fucking great. I have a moderately complex layout set up for my org-mode workflow (tasks list top left, agenda top center, notes file top right, kanban board bottom-left, and a scratch buffer bottom right), and they all load the same way every time. And I have project-specific layouts that get auto-loaded when I open that projectile project, and I have a general programming one as well. All of these took less than an hour to set up and work completely flawlessly.
1 comments
shadeless 3573 days ago
I haven't used layouts much, but that sounds very useful.

Do you have your dotfiles somewhere online? Or could you put up the code needed for that setup in a gist/pastebin?

link
nameless912 3573 days ago
I don't have the dotfile up anywhere, but I can run you through the basics really quickly:

* SPC-l gives you the layouts micro-state, which allows you to do all of this. First, set up your layout however you'd like, then open up the micro-state and run the save-as command (SPC-l-S) and that will allow you to save the layout to a layouts file somewhere deep in the bowels of Spacemacs.

* When you're ready to use your layout, use SPC-l-L to load the layout from a file. Type its name (Helm is used, so you get narrowing/fuzzy-find for free) and the layout will load. Note that if you already had another layout loaded, it will load it to the next workspace (accessible through SPC-l-<workspace-number>).

* As for the org Kanban board, check here: http://www.draketo.de/light/english/free-software/el-kanban-... To add this to spacemacs, just open your .spacemacs file (SPC-f-e-d) and add `kanban` to your `dotspacemacs-additional-packages` list.

link